180mm Polishing Bonnet Hook & Loop Concave (SPC00125)

Tork Craft

180mm Polishing Bonnet Hook & Loop Concave (SPC00125)

R339.00 Incl. VAT

50 available. Delivery 3-6 working days. Learn more.

Or split into 4x interest-free payments Learn more
Purchase this product now and earn 34 Bench Marks!

SKU: SPC00125 Category:

Product Description

hook and loop polishing wool buff


Diameter:
Ø180mm
Use backing pad:

SPC00119

 Application:

The polishing wool buff should be used with an automotive polisher.
Different polishes and waxes can be used with the buff. The buff is fastened
onto a rubber backing pad with hook and loop. Make sure the diameter of the polishing buff is
the same as the backing pad’s diameter.

It is necessary to polish a vehicle body panel when:

  • The panel has been newly painted with a clear-coat.
  • Shallow scratch marks need to be removed.
  • The panel has suffered from oxidation.
  • Swirl marks and hologram defects need to be removed.

TIP:
The buff is washable after use if the polishing compound is soluble.

hook and loop polishing wool buff range:

ORDER NO.DIAMETERUSE BACKING PAD
SPC00123ø125mm
SPC00120
SPC00125ø180mm
SPC00119

Recommended polishing compounds to use:


  • Liquid Shine™
    High cut
    – Features a silicone, wax and filler free polishing
    compound to give a high gloss finish on fresh or cured paint. It is capable
    of removing P1500 grit sanding marks. It can be used on automotive paints,
    marine gel-coats and on composite surfaces.

  • Liquid Shine™
    Fine cut
    – similar to the High cut polishing compound, but it
    is designed for use on a ceramic and scratch resistant clear-coat. It is
    capable of removing P2000 scratch marks.

  • Liquid Shine™
    Zero swirl
    – Very low abrasive for the final step of polishing.
    Removes holograms and swirl marks. Use a soft compounding sponge as a final
    step

Additional Information

Brand

Tork Craft

Steps to take when polishing a panel:

1. Preparing the panel:
  • Sometimes a panel has fine over-spray left from spraying the clear-coat. This needs to be removed by lightly sanding with a fine abrasive paper. All over-spray need to be sanded out up to P1500 grit.
  • The panel should be washed when all spray-finishing defects have been removed. Any dirt particles could cause scratch marks when polishing.
  • Tight curves and ends of the panel should be masked-off to prevent the effects caused by point pressure. The polisher should always be used on flat surfaces.
2. Applying the polishing compound:
  • A five rand coin amount of polishing compound should be applied to the buff. Switch the polisher to it’s lowest speed setting.
  • Switch on the polisher and gradually spread the polishing compound over the panel.
  • Keep moving the polisher on the panel to have as little amount of pressure and friction.
  • The polishing compound will remove the scratch marks caused by the P1500 sand paper and it will bring out an impressive gloss finish.
  • Remove the masking from the panels and apply the polishing compound to a microfiber cloth. Hand polish (by moving your hand in a small circular motion) the tight curves and ends in the panels until the same finish is achieved as from the polisher.
3. Wash the panel when finished:
  • Wash the panel after polishing to remove any residue from the polishing compound.

Reviews

There are no reviews yet.

Be the first to review “180mm Polishing Bonnet Hook & Loop Concave (SPC00125)”

Pre-Sale Questions

There are no questions yet.

Ask a question about “180mm Polishing Bonnet Hook & Loop Concave (SPC00125)”

Works well with

Suggest more products